Chapter 14: Syslog Commands; Audmsg - Siemens scalance WLC711 Reference Manual

14
syslog Commands

audmsg

facility
stationevents
svcmsg
syslogip
This section describes commands to configure System Log settings on the Wireless Appliance. These
commands are located in the syslog context of the CLI.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the syslog context:
•
audmsg on page 220
•
facility on page 221
•
stationevents
•
svcmsg on page 222
•
syslogip on page 222
audmsg
Use the command to enable service messages. Use the no form of the command to disable
audmsg
them.
audmsg
no audmsg
Parameters
None
Example
The following example enables service messages on the Wireless Appliance:
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
on page 221
:syslog# audmsg
220