Siemens scalance WLC711 Reference Manual page 134

nonUnicastQuota
Use the
nonUnicastQuota
transmits non-unicast packets (broadcast and multicast traffic) for each configured Beacon period. For
each non-unicast packet transmitted, the system calculates the airtime used by each packet and drops
all packets that exceed the maximum percentage. By restricting non-unicast traffic, you limit the
impact of broadcasts and multicasts on overall system performance. The
is accessible from all ap: radio contexts of the CLI.
nonUnicastQuota value
Parameters
value
Example
The following example sets the maximum non-unicast traffic percentage to 50%:
WLC.siemens.com
optimized-mcast
Use the
optimized-mcast
optimized-mcast
<serial> radio1 and radio2 contexts of the CLI.
optimized-mcast enable | disable
Parameters
enable
disable
Example
The following example enables optimized multicast on radio1:
WLC.siemens.com
pmode
Use the command to configure the Protection Mode, which will protect 802.11g client
pmode
transmissions from interruption by 802.11b clients. The
contexts of the CLI.
Use none only if the Wireless AP will NOT be servicing 802.11b clients, and there are no 802.11b clients or
Wireless APs sharing the same air space.
pmode ( none | auto | always )
SCALANCE WLC711 CLI Reference Guide
command to specify the maximum percentage of time that the AP
Specifies the maximum non-unicast traffic percentage allowed. Valid values are
10-100.
:ap:defaults:11n:radio2# nonUnicastQuota 50
command to enable or disable the optimized-multicast feature. The
command is accessible from the 11n, ap37xx, ap38xx, ap3801, dualband, std, and
Enables the optimized multicast feature on this radio.
Disables the optimized multicast feature on this radio
:ap:defaults:ap37xx:radio1# optimized-mcast enable
nonUnicastQuota
command is accessible from all ap: radio2
pmode
ap Commands
nonUnicastQuota
command
134