Siemens scalance WLC711 Reference Manual page 360

exceptions
Use the
exceptions
CLI for b@ac, physical, and routed topologies. In this context, you can configure exception filters.
The following commands are available in the topology:<named-topology>:l3: exceptions context.
•
config on page 360
•
create on page 361
•
delete on page 362
•
move on page 363
•
show on page 363
config
Use the command to configure an existing exception filter. The
config
from the topology:<named-topology>:l3:exceptions context of the CLI for b@ac, physical, and routed
topologies.
config pos proto {udp|tcp|ah|esp|none|icmp|gre|0-255} A.B.C.D/0-32 [(port
0-65535[ 0-65535])|(type 0-255 [0-255])] in (none|src|dst|both) (allow|deny)
Parameters
pos
proto {udp|tcp|ah|esp|none |
icmp|gre|0-255}
A.B.C.D/0-32
(port 0-65535[ 0-65535])
(type 0-255 [0-255])
SCALANCE WLC711 CLI Reference Guide
command to enter the topology:<named-topology>:l3: exceptions context of the
Specifies a position value for this filter in the filter list. Valid values are from
0–255.
Specifies the protocol for this filter rule by number or name. Valid number
values are from 0–255. Valid name values are:
•
udp - UDP protocol
•
tcp - TCP protocol
•
ah - Authentication Header protocol
•
esp - Encapsulating Security Payload protocol
•
none - No protocols
•
icmp - ICMP protocol
•
gre - Generic Route Encapsulation protocol
Specifies the IPv4 IP address and mask.
Specifies a TCP or UDP port or port range to which this filter rule will be
applied. The first value specifies either the port or the start of a port range.
The second value optionally specifies the end of a port range. This
parameter is only valid when either TCP or UDP is the specified protocol.
Valid port values are from 0–65535.
Specifies an ICMP type or range of ICMP types. This parameter is only valid
when ICMP is the specified protocol. Valid values are from 0–255.
topology Commands
exceptions
command is available
config
360