15
time Commands
clock
date
ntp
ntpip
tz
Network elements on the Wireless Appliance can be synchronized to a universal clock in one of two
ways:
•
using the Wireless Appliance's own system time
•
using the Network Time Protocol
The commands described in this section are used to select and configure these options, and are located
in the time context of the CLI.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
After you run any of the
The following commands are available in the time context:
•
clock
on page 224
•
date
on page 225
•
ntp
on page 225
•
ntpip
on page 226
•
tz
on page 226
clock
Use the
command to set the system time.
clock
The Network Time Protocol must be disabled before this command can be used. For more information,
see
ntp
on page 225.
After you run the
clock hh:mm
Parameters
hh
mm
SCALANCE WLC711 CLI Reference Guide
commands, run the
time
command, run the apply command to implement the changes.
clock
Specifies the current hour (in 24 hour clock format)
Specifies the current minute
command to implement the changes.
apply
224