•
country
on page 109
•
lbs-status
on page 109
•
led-mode
on page 110
•
lldp
on page 111
•
persistent
on page 111
•
radio1
on page 112 — See
ap:defaults:dualband:radio1 context.
•
radio2
on page 114 — See
ap:defaults:dualband:radio2 context.
•
telnet
on page 117
learnac
Use the
command to allow the Wireless AP to provide its own WLC Search List. Use no form
learnac
of the command to disable this feature. The
context of the CLI.
If you disallow the Wireless AP from providing its own WLC Search List, you should specify the
controller's static IP address by running the
146. If you disallow the Wireless AP from providing its own WLC Search List and do not specify the
controller's static IP address, the Wireless AP uses the SLP to discover the controller.
After you run the
learnac
learnac no learnac
Parameters
None
Examples
The following example allows each Wireless AP to provide its own WLC Search List:
WLC.siemens.com
std
The
command refers to context std, which contains commands to configure the default AP
std
settings for the standard Wireless AP. The
the CLI.
The following commands are available in the ap:defaults:std context:
•
balanced-power
•
bcast_disassoc
•
client_session
on page 108
•
country
on page 109
•
lbs-status
on page 109
•
led-mode
on page 110
SCALANCE WLC711 CLI Reference Guide
Radio Commands
Radio Commands
learnac
aclist
command, run the
:ap:defaults# learnac
std
on page 108
on page 117 for commands in the
on page 117 for commands in the
command is accessible from the ap:defaults
command. For more information, see
command to implement the changes.
apply
command is accessible from the ap:defaults context of
ap Commands
learnac
aclist
on page
90