Siemens scalance WLC711 Reference Manual page 314

Example
The following example assigns the cos my-cos to the WLAN service:
WLC.siemens.com
default-topology
Use the
default-topology
default topology for the specified WLAN service. You can also use the
to unassign the default topology. The
wlans:<WLAN-service-name> context of the CLI.
For information about B@AC, B@AP, and routed topologies, refer to
340.
default-topology Default topology name | none
Parameters
Default topology name
none
Example
The following example assigns the topology FS-REMOTE to the WLAN service:
WLC.siemens.com
default-traffic-mirror
Use the
default-traffic-mirror
command is accessible from the wlans:<named-wlan> context of the CLI.
traffic-mirror
default-traffic-mirror (prohibited | enable-both-directions | enable-in-
direction-only)
Parameters
prohibited | enable-
in-both-directions |
enable-in-direction-
only
Example
The following example configures the default traffic mirror to be enabled in both directions:
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:wlans:gp1# default-cos my-cos
command to assign an existing B@AC, B@AP, or routed topology as the
default-topology
Specify default topology to assign to the WLAN service
Unassign the default topology from the WLAN service
:wlans:gp1# default-topology FS-REMOTE
command to configure the default traffic mirror. The
Configures the default traffic mirror for prohibited, enabled in both directions, or
enabled in the in direction only.
:wlans:HT_BR# default-traffic-mirror enable-both-directions
default-topology
command is accessible from the
topology Commands
wlans Commands
default-topology
command
on page
default-
314