Ping; Radtest - Siemens scalance WLC711 Reference Manual

stationlog
send_station_trap
Examples
The following example sets the Wireless Appliance's log level to Minor:
WLC.siemens.com
Successfully set ac log level to Minor (3)
The following example sets the Wireless Appliance log level to Information and enables station event
reporting on the the controller station log:
WLC.siemens.com
The following example sets the AP's log level to Information:
WLC.siemens.com

ping

Use the command to ping an IP address. The ping command accepts an optional parameter that
ping
specifies the source ip address to be used by the command. If this optional source is provided, ping
uses the IP address of the specified interface as the source IP address.
ping source-interface name name | number id ip address
Parameters
source-interface name name |
number id
IP Address
Usage
You can identify the source IP using its interface name or, for short, the identifier returned by the
command. Interface name is the name of any topology with L3 configuration (Physical,
topology l3
Admin, B@AC or Routed).

radtest

Use the command to test the RADIUS server's connectivity and configuration.
radtest
radtest vns_name | username | password
SCALANCE WLC711 CLI Reference Guide
Enables or disables station session event reporting on the controller station events
log.
Enables or disables station event forwarding as SNMP traps.
# loglevel ac 3
# loglevel ac 4 stationlog enable
# loglevel ap 4
Specifies the address of the source interface you want to send pings
from, either by interface name or ID.
Specifies the IP address you want to ping. The IP address can be
either IPv4 (A.B.C.D) or IPv6 (A:B:C:D:E:F:G:H) format.
root Commands
ping
show
39