Siemens scalance WLC711 Reference Manual page 304

Example
The following example moves the RADIUS server in the RADIUS server list position 2 to position 1 in the
RADIUS server list:
WLC.siemens.com
WLC.siemens.com
nasid
Use the command to identify the Network Access Server (NAS) to be used with the RADIUS
nasid
server being configured. The
name>:auth context of the CLI.
After you run the
nasid
nasid string | vnsname
Parameters
string
vnsname
Usage
The NAS ID defaults to the VNS name if this command is not used to specify a NAS ID.
You must be in RADIUS server configuration mode for the
command to enter RADIUS server configuration mode. For more information, see
config
page 296.
Example
The following example sets the NAS ID for this RADIUS server configuration to the VNS name for the
cnl-AAA WLANS auth context:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
NAS identifier: Use VNS name
nasip
Use the command to configure the NAS IP address to be used with the RADIUS server being
nasip
configured. The
nasip
the CLI.
After you run the
nasip
nasip A.B.C.D | vnsip
SCALANCE WLC711 CLI Reference Guide
:wlans:cnl-AAA:auth# move 2 1
:wlans:cnl-AAA:auth# apply
command is accessible from the wlans:<WLAN-service-
nasid
command, run the
apply
Specify the ID for the NAS
Specifies that the VNS name should be used for the NAS ID
:wlans:cnl-AAA:auth# nasid vnsname
:wlans:cnl-AAA:auth# apply
:wlans:cnl-AAA:auth# show nasid
command is accessible from the wlans:<WLAN-service-name>:auth context of
command, run the
apply
command to implement the changes.
command to be available. Use the
nasid
command to implement the changes.
wlans Commands
nasid
config on
304