Chapter 6: L2Ports Commands; Esan; Jumbo-Frames - Siemens scalance WLC711 Reference Manual

6
l2ports Commands

esaN

jumbo-frames

<named-LAG-port>
This section describes commands to enable and disable ports on the Wireless Appliance. These
commands are located in the l2ports context of the CLI. L2 port configuration is performed within a
named topology context. See
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the l2ports context:
•
esaN on page 158
•
jumbo-frames
•
show
•
<named-LAG-port>
esaN
The command moves you into the context l2ports:esaN (where variable N refers to the physical
esaN
data port number). This context contains the port command which enables or disables ports.
jumbo-frames
Use the
jumbo-frames
controller. The jumbo frames feature allows for frames greater than 1500 bytes (maximum MTU frame
size).
jumbo-frames enable | disable
Parameters
enable
disable
Usage
The standard Ethernet frame MTU for untagged packets is 1518 bytes including the 18 Ethernet header
bytes. The standard Ethernet frame MTU for tagged packets is 1522 bytes.
SCALANCE WLC711 CLI Reference Guide
l2 on page 344 for L2 port configuration information.
on page 158
on page 159 — See for commands in the l2ports:<named-LAG-port> context.
command to enable or disable jumbo frames on all Layer 2 ports on the
Enables jumbo frames on all controller Layer 2 ports.
Disables jumbo frames on all controller Layer 2 ports.
158