DCS Commands
The commands in this section are common to radio1 and
The following commands are variously available in the radio1 and radio2 dcs contexts:
•
channel_plan
on page 140
•
mode
on page 141
•
noise_threshold
•
occupancy_threshold
•
radio_channels
•
update_period
Commands entered in the dcs context do not need to be followed by "apply" in order for them to take
effect.
channel_plan
Use the
channel_plan
command is accessible from the ap:<serial> and ap:defaults:11n, ap37xx, ap38xx,
channel_plan
ap3801, , and std radio dcs contexts of the CLI.
The parameters available in the
command in the same radio context.
Syntax: (11n, 4102, ap37xx, ap38xx, ap3801, dualband, std, and <serial> radio1)
channel_plan all-non-dfs | all | channel[, channel]
Parameters
all-non-dfs
all
channel[, channel]
Syntax: (11n, 4102, ap37xx, ap38xx, ap3801, dualband, std, and <serial> radio2)
channel_plan auto | 3-channel | 4-channel | channel[, channel]
Parameters
auto
3-channel
4-channel
channel [,channel]
SCALANCE WLC711 CLI Reference Guide
on page 141
on page 142
on page 142
on page 143
command to customize the channel plan for the Wireless AP's Radio 1. The
channel_plan
Radio 1 uses all non-DFS channels.
Radio 1 uses all channels
Radio 1 uses the channels that are listed, separated by commas.
Radio 2 uses 3 channels for countries supporting 11 channels and 4 channels for
countries supporting 13 channels.
Radio 2 uses 3 channels.
Radio 2 uses 4 channels.
Radio 2 uses the channels that are listed, separated by commas.
commands in various contexts.
radio2 dcs
command are determined by the setting of the
ap Commands
DCS Commands
mode
140