Siemens scalance WLC711 Reference Manual page 313

Usage
After this command has been executed for the dynamic mesh WLAN service being configured, it will
no longer be available.
Example
This example selects the 5 GHz radio band for the dynamic mesh WLAN service named mesh1-wlan:
WLC.siemens.com
cp-http
Use the command to enable HTTP support for a WLANs service captive portal context.
cp-http
cp-http enable | disable
Parameters
enable
disable
Usage
The internal or splash authentication mode must be set for this command to be available. For more
authentication mode information, see
Example
The following example enables HTTP support for the Lab126-12-GuestSpl WLAN service:
WLC.siemens.com
default-cos
Use the
default-cos
specified WLAN service. You can also use the
command is accessible from the wlans:<WLAN-service-name> context of the CLI.
default-cos
For information about Class of Service, refer to
default-cos named-cos | none
Parameters
named-cos
none
SCALANCE WLC711 CLI Reference Guide
:wlans:mesh1-wlan# backhaul-radio a
Enables HTTP support for the current context
Disables HTTP support for the current context
mode on page 302.
:wlans:Lab126-12-GuestSpl:auth:captiveportal# cp-http enable
command to assign an existing Class of Service (CoS) as the default CoS for the
default-cos
cos Commands
Specify a named-cos to assign to the WLAN service as a default CoS.
unassign the default CoS from the WLAN service
wlans Commands
command to unassign the default cos. The
on page 384.
cp-http
313