Siemens scalance WLC711 Reference Manual page 111

lldp
Use the command to enable the broadcast of the LLDP protocol by a Wireless AP. Use the no
lldp
form of the command to disable LLDP. The
ap:defaults:11n, ap37xx, ap38xx, ap3801, and std contexts of the CLI.
lldp Announcement Interval | Announcement Delay no lldp
Parameters
Announcement Interval
Announcement Delay
Examples
The following example enables LLDP for the default Wireless AP configuration with an announcement
interval of 30 seconds, and an announcement delay of 2:
WLC.siemens.com
If SNMP is enabled to publish on the Wireless Appliance and you enable LLDP, the following message is
displayed:
WARNING: SNMP is set to publish. How Do you wish to continue? (C) Cancel (P)
Proceed (O) Disable SNMP publishing and proceed
Type one of the following:
•
C – Cancels the LLDP configuration and returns to the AP context.
•
P – Enables LLDP and maintains SNMP running
•
O – Enables LLDP and disables SNMP publishing
persistent
Use the
persistent
controller. Use the no form of the command to disable the feature. The
accessible from the ap:<serial> and ap:defaults:11n, ap37xx, ap38xx, ap3801, and std contexts of the CLI.
persistent no persistent
Parameters
None
SCALANCE WLC711 CLI Reference Guide
lldp
Specifies the scheduled frequency, measured in seconds, in which the
Wireless AP advertises its information by sending a new LLDP packet.
Range is 5 to 32768.
Specifies the delay, measured in seconds, between successive LLDP
frame transmissions that is initiated by a value/status change in the
LLDP local systems MIB. Range is 1 to 1/4 x Announcement Interval
value.
:ap:defaults:11n# lldp 30 2
command to enable the radio service to be restarted even in the absence of the
command is accessible from the ap:<serial> and
persistent
ap Commands
lldp
command is
111