Siemens scalance WLC711 Reference Manual page 406

Example
The following example enables call station replacement:
WLC.siemens.com
secure-tunnel
Use the
secure-tunnel
command is accessible from the site:<named-site> and ap:defaults:38xx contexts.
tunnel
secure-tunnel (disable | control | data | debug)
Parameters
disable
control
data
debug
Usage
If enabling a secure tunnel, specify the type of traffic this tunnel will encrypt and carry: control traffic, or
control and data traffic. Secure tunneling can also be used for debug mode (keys are preserved without
encryption).
Example
The following example enables a secure tunnel that encrypts control and data traffic on site1:
WLC.siemens.com
secure-tunnel-ap
Use the
secure-tunnel-ap
APs on this site. The
secure-tunnel-ap (enable | disable)
Parameters
enable | disable
Usage
The
secure-tunnel
SCALANCE WLC711 CLI Reference Guide
:site:site1# replace-station-id enable
command to enable or disable a secure tunnel on this site. The
Disables a secure tunnel on this site.
Enables a secure tunnel by encrypting control traffic between the AP and the
controller.
Enables a secure tunnel by encrypting control and data traffic between the AP and
the controller.
Enables tunnel in debug mode, which preserves keys without encryption.
:site:site1# secure-tunnel data
command to enable or disable the encryption of control traffic between
command is accessible from the site:<named-site> context.
secure-tunnel-ap
Enables or disables secure tunnels between APs on this site.
command must be enabled before the command can be run.
secure-tunnel-ap
site Commands
secure-tunnel
secure-
406