Siemens scalance WLC711 Reference Manual page 178
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Example
The following example creates a scan group named South-Block:
WLC.siemens.com
both channel all type active serial 0500006072051354 0500006072051427
0500006062051048 0500006062051040
<scan group name>
The <scan group name> is a context, which contains commands to modify the attributes for a specified
scan group, where the parameter <scan group name> refers to the scan group's name.
The
<scan group name>
The following commands are available in the mitigator:scgroup:<scan group name> context:
•
aplist
on page 188
•
channel
on page 178
•
dtime
on page 178
•
interval
on page 179
•
name
on page 194
•
radio
on page 179
•
security-scan
on page 180
•
start
on page 180
•
show
on page 181
•
type
on page 180
channel
Use the
command to modify the Channel List — scanning on all channels or on the current
channel
channels.
After you run the
channel
channel all | current
Parameters
all
current
Example
The following example sets the current channel to be scanned:
WLC.siemens.com
WLC.siemens.com
dtime
Use the
command to modify the Channel Dwell Time of the scan group.
dtime
SCALANCE WLC711 CLI Reference Guide
:mitigator:scgroup# sgname South-Block 100 dtime 300 radio
command is accessible from the mitigator:scgroup context of the CLI.
command, run the
apply
Specifies all channels to be scanned
Specifies the current channel to be scanned
:mitigator:scgroup:South Block# channel current
:mitigator:scgroup:South Block# apply
command to implement the change.
Radar Commands
<scan group name>
178
Advertisement
Table of Contents
