Siemens scalance WLC711 Reference Manual page 177

To verify that the change has been made, use the
WLC.siemens.com
To remove the IP address, the no form of the command is used, followed by the
implement the change:
WLC.siemens.com
WLC.siemens.com
scgroup
The command refers to context scgroup, which contains commands to create and delete scan
scgroup
groups. Scan groups are used for Out-of-Service scans on AP36xx series APs (legacy Mitigator scans).
The command is accessible from the mitigator context of the CLI.
scgroup
For In-Service scanning of AP37xx series APs in scan profiles, see the
The following commands are available in the mitigator:scgroup context:
•
sgname on page 177
•
<scan group name>
context.
sgname
Use the command to create a scan group. Use the no form of the command to delete the scan
sgname
group. The
sgname
After you add the Wireless APs to the scan group, run the
sgname scan group name 10-120 [dtime 200-5000] [radio1 |radio2|both] [channel
all|current] [type active|passive] [serial serial...]
no sgname scan group name
Parameters
scan group name
10-120
dtime 1-1000
radio1 | radio2 | both
channel all | current
type active | passive
serial
serial
SCALANCE WLC711 CLI Reference Guide
:mitigator# show wcswip
:mitigator# no wcswip 123.456.789.101
:mitigator# apply
on page 178 — See for commands in the mitigator:scgroup:<scan group name>
command is accessible from the mitigator:scgroup context of the CLI.
Specifies the scan group name
Specifies the scan time interval
Specifies the Channel Dwell Time of the scan group
Specifies radios — radio 1, radio 2, or both
Specifies the channels to be scanned — all or current
Specifies the scan type — active or passive
Specifies to add the Wireless APs by their serial numbers to the scan group.
Specifies the serial number of the Wireless APs that are to be added to the scan
group
command:
show
page 181
command to implement the changes.
apply
Radar Commands
scgroup
command to
apply
command.
177