Siemens scalance WLC711 Reference Manual page 301

Example
The following example enables automatic authentication of authorized users on the cnl-mac WLANS
service:
WLC.siemens.com
WLC.siemens.com
mac-allow-unauthorized
Use the
mac-allow-unauthorized
mac-allow-unauthorized
context of the CLI.
After you run the
mac-allow-unauthorized
changes.
mac-allow-unauthorized enable | disable
Parameters
enable | disable
Usage
The
mac-allow-unauthorized
authentication is enabled, using the
information, see mode
Example
The following example enables the authentication of unauthorized users for the cnl-mac WLANS
service:
WLC.siemens.com
WLC.siemens.com
mac-roam
Use the
mac-roam
roam. The
mac-roam
CLI.
After you run the
mac-roam
mac-roam none | on-roam | area-change
Parameters
none
on-roam
area-change
SCALANCE WLC711 CLI Reference Guide
:wlans:cnl-mac:auth# mac-auto-authenticate enable
:wlans:cnl-mac:auth# apply
command to allow the authentication of unauthorized users. The
command is accessible from the wlans:<WLAN-service-name>:auth
Specify to enable or disable the authentication of unauthorized users on this
WLANS service
command is available in all authentication modes, if MAC
mac enable
on page 302. For
mac
:wlans:cnl-mac:auth# mac-allow-unauthorized enable
:wlans:cnl-mac:auth# apply
command to enable, disable, or allow area change for MAC based authentication on
command is accessible from the wlans:<WLAN-service-name>:auth context of the
command, run the
Specify MAC authentication on roam as disabled. Default value: none.
Specify Mac authentication on roam as enabled.
Specify Mac authentication on roam as allowing area change.
command, run the
apply
command. For authentication
command information, see
command to implement the changes.
apply
wlans Commands
mac-allow-unauthorized
command to implement the
command
mode
mac on page 299.
301