Siemens scalance WLC711 Reference Manual page 355
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Example
The following example specifies the IP addresses of two DNS servers:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
domain
Use the
command to configure a domain name. The
domain
topology:<named-topology>:l3:dhcp context of the CLI for b@ac, physical, and routed topologies. This
command is visible only when mode is set to local. See
domain domain name | none
Parameters
domain name
none
Example
The following example sets the domain name as my-domain:
WLC.siemens.com
WLC.siemens.com
exclude
Use the
command to exclude an IP address or a range of IP addresses from the DHCP
exclude
Address Range. The
context of the CLI for b@ac, physical, and routed topologies. This command is visible only when mode
is set to local. See
mode
exclude A.B.C.D [A.B.C.D] [delete | (comment comment string)]
Parameters
A.B.C.D[ A.B.C.D]
delete
comment comment string
Example
The following example excludes the address range 10.0.1.10–10.0.1.20:
WLC.siemens.com
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:topology:test:l3:dhcp# mode local
:topology:test:l3:dhcp# dns 192.168.1.2, 192.168.1.3
:topology:test:l3:dhcp# apply
Specifies the domain name or an IPv4 address.
Clears the domain name.
:topology:test:l3:dhcp# mode local
:topology:test:l3:dhcp# domain my-domain
command is available from the topology:<named-topology>:l3:dhcp
exclude
on page 358.
Specifies the IP address or range of IP addresses.
Clears the IP addresses.
A comment about the excluded IP address or range of IP addresses.
:topology:test:l3:dhcp# mode local
:topology:test:l3:dhcp# exclude
command is available from the
domain
mode
on page 358.
10.0.1.10 10.0.1.20
topology Commands
domain
355
Advertisement
Table of Contents
