Siemens scalance WLC711 Reference Manual page 402

Example
The following example sets the authentication password to "user99" for site1:
WLC.siemens.com
ping
Use the command to ping the specified IP address for a response. The
ping
accessible from the site:<named-site> context.
ping [source-interface (name name) | (number id)] ip address
Parameters
[source-interface (name
name) | (number id)]
ip address
Example
The following example pings the RADIUS server configured for site1:
WLC.siemens.com
protocol
Use the
protocol
is accessible from the site:<named-site> context.
protocol (CHAP|PAP|MS-CHAP|MS-CHAP2)
Parameters
CHAP|PAP|MS-CHAP|MS-
CHAP2
Usage
The CLI <named-site> context must be in config mode for a RADIUS server to execute the
command. Use the
config mode.
Example
The following example sets the authentication protocol to PAP:
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:site:site1# password user99
Specifies that the source interface be pinged, by name or by ID number.
Specifies an IP address for the server. The IP address can be either IPv4
(A.B.C.D) or IPv6 (A:B:C:D:E:F:G:H) format.
:site:site1# ping source-interface name james 192.168.77.7
command to set the authentication password for this site. The
Specifies an authentication protocol type. Valid values are CHAP, PAP, MS-CHAP,
and MS-CHAP2.
config <radius name>
:site:site1# protocol PAP
command to enter config mode. Use config exit to exit
site Commands
ping
command is
ping
command
protocol
protocol
402