arp-proxy enable | disable
Parameters
enable
disable
Example
This example enables the ARP proxy for the test topology:
WLC.siemens.com
multicast
Use the
multicast
for b@ac, b@ap, physical, and routed topologies.
The following commands are available in the topology:<named-topology>:l2: multicast context.
•
config
on page 345
•
create
on page 346
•
delete
on page 346
•
filter
on page 346
•
move
on page 347
config
Use the
command to configure an existing multicast filter. To create a multicast filter, use the
config
command. See
create
topology:<named-topology>:l2:multicast context of the CLI for b@ac,, b@ap, and routed topologies.
config pos|default (A.B.C.D[/<0-32] | vocera | svp | mdns) on|off
Parameters
pos|default
A.B.C.D[/0-32] | vocera | svp
| mdns
on|off
Example
This example configures an existing multicast filter:
WLC.siemens.com
225.1.1.0/32 on
SCALANCE WLC711 CLI Reference Guide
Enables the ARP proxy for this topology.
Disables the ARP proxy for this topology.
:topology:test:l2# arp-proxy enable
command to enter the topology:<named-topology>:l2: multicast context of the CLI
create
on page 346. The
Specifies the priority of filter rule (0–255) or default filter rule.
Specifies the IP address and mask of a multicast group or that the multicast
group is pre-defined.
•
svp: Spectralink SVP (224.0.1.116)
•
vocera: Vocera Mcst (230.230.0.0/20)
•
mdns mDNS/Bonjour (224.0.0.251)
Specifies whether wireless replication is enabled. The default is off.
:topology:techpubs_test_ac:l2:multicast# config 1
command is available from the
config
topology Commands
multicast
345