Port; Publish-Ap - Siemens scalance WLC711 Reference Manual
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Parameters
string
Examples
The following example specifies the location of the SNMP agent:
WLC.siemens.com
port
Use the
command to specify the destination port for the SNMP traps.
port
port value
Parameters
value
Examples
The following example sets the trap port of the SNMP manager to 163:
WLC.siemens.com
publish-ap
Use the
publish-ap
interface to the Wireless Appliance.
publish-ap (enable|disable)
Parameters
enable | disable
Examples
The following example enables SNMP publishing:
WLC.siemens.com
If you attempt to enable SNMP publish when LLDP is enabled on one or more APs, you will get the
following warning:
WARNING: LLDP is enabled for some Wireless APs. Would you like to continue? (C)
Cancel (P) Proceed (O) Disable LLDP and proceed
SCALANCE WLC711 CLI Reference Guide
:snmp# location Blue Office - Second Floor
Specifies the trap port of the SNMP manager. The value can range from 1 to 65535.
:snmp# port 163
command to enable or disable SNMP publishing of the access point as an
Enables or disables publishing of the access point as an interface to the controller.
:snmp# publish-ap enable
Specifies the location Wireless Appliance running the
SNMP agent
snmp Commands
port
215
Advertisement
Table of Contents
