Siemens scalance WLC711 Reference Manual page 327

WLC.siemens.com
Priority override: enable
priority-override-dscp
Use the
priority-override-dscp
priority processing and use a single DSCP codepoint for the WLANS. The
command is accessible from the wlan:<WLAN-service-name>:qos-policy context of the CLI.
After you run the
priority-override-dscp
changes.
priority-override-dscp 0-64
Parameters
0-64
Usage
This command is only active if the
information, see priority-override
Example
The following example overrides all existing DSCP codepoint assignments and uses DSCP codepoint 2
for the CNL-7-CP WLANS:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
DSCP marking: 2
priority-override-up
Use the
priority-override-up
processing and configure a single Service Class value for the WLANS. The
command is accessible from the wlan:<WLAN-service-name>:qos-policy context of the CLI.
After you run the
priority-override-up
changes.
priority-override-up 0-7
Parameters
0-7
Usage
This command is only active if the
information, see priority-override
SCALANCE WLC711 CLI Reference Guide
:wlans:CNL-7-CP:qos-policy# show priority-override
command to override existing DSCP codepoint assignments for
command, run the
Specifies a DSCP codepoint value. Default value: 0.
priority-override
on page 326.
:wlans:CNL-7-CP:qos-policy# priority-override-dscp 2
:wlans:CNL-7-CP:qos-policy# apply
:wlans:CNL-7-CP:qos-policy# show priority-override-dscp
command to override existing Service Class settings for priority
command, run the
Specifies a Service Class value. Default value: 1.
priority-override
on page 326.
priority-override-dscp
priority-override-dscp
command to implement the
apply
command has been enabled. For more
priority-override-up
command to implement the
apply
command has been enabled. For more
wlans Commands
327