Siemens scalance WLC711 Reference Manual page 135

Parameters
none
auto
always
Example
The following example configures the Wireless AP to use Protection Mode at all times:
WLC.siemens.com
prate
Use the command to adjust the Protection Rate. The
prate
radio2 contexts of the CLI when radio mode includes 'g' (e.g. g, b/g, b/g/n, or n-strict).
prate ( 1 | 2 | 5.5 | 11 )
Parameters
1 | 2 | 5.5 | 11
Example
The following example adjusts the Protection Rate to 5.5 Mbps:
WLC.siemens.com
preamble
Use the
preamble
ap: radio2 contexts of the CLI.
preamble ( short | long )
Parameters
short
long
Example
The following example enables the long option for the preamble type:
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
Deactivates Protection Mode
Indicates that Protection Mode will be used only when 802.11b clients or Wireless
APs are detected
Indicates that Protection Mode will remain active at all times
:ap:defaults:11n:radio2# pmode always
Specifies the Protection Rate in Mbps
:ap:defaults:11n:radio2# prate 5.5
command to set the preamble type. The
Specifies short preambles
Specifies long preambles
:ap:defaults:11n:radio2# preamble long
command is accessible from all ap:
prate
command is accessible from all
preamble
ap Commands
prate
135