Siemens scalance WLC711 Reference Manual page 96

name load group name
Parameters
load group name
Usage
After you change the name of the load group and apply the change (with the
ap:load-groups:<named-load-group> context retains the previous name of the load group. To change
the ap:load-groups:<named-load-group> context to the new name of the load group, you exit the
context and then enter the ap:load-groups:<named-load-group> context using the new name.
Example
The following example changes the name of loadgroup1 to lg_lab:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Available commands are:
create
delete
end
exit
base mode
lg_lab
logout
show
WLC.siemens.com
WLC.siemens.com
radio-load
Use this command to configure the maximum number of clients for each radio when the radio load
control feature is enabled. The
load-group> context of the CLI, for the radio type of load group.
radio-load radio1 | radio2 max-clients
Parameters
radio1 | radio2
max-clients
Usage
For access to this command, the radioN-loadcontrol command must be enabled.
SCALANCE WLC711 CLI Reference Guide
The new name of the load group.
:ap:load-groups:loadgroup1# name lg_lab
:load-groups:loadgroup1# apply
:load-groups:loadgroup1# exit
:load-groups# ?
Create load group
Delete load group
Return to the base mode
Return to the previous mode if not in the
Configure details for load group lg_lab
Exit the shell
:ap:load-groups# lg_lab
:load-groups:lg_lab#
command is accessible from the ap:load-groups:<named-
radio-load
Specifies the radio being configured.
Specifies the maximum number of clients for the specified radio. Can be an
integer between 5 and 60.
ap Commands
radio-load
command), the
apply
96