Siemens scalance WLC711 Reference Manual page 265

Examples
The following example specifies that the role named "auth-users" should be used as the default role for
authenticated users for the VNS named VNS1:
WLC.siemens.com
This example specifies that the same role used as the default role for non-authenticated users should
be used for authenticated users for the VNS named VNS1:
WLC.siemens.com
WLC.siemens.com
non-auth
Use the
non-auth
available from the vnsmode:<named-VNS> context.
After you run the
non-auth
non-auth role-name
Parameters
role-name
Usage
When you change the default non-authenticated role for this VNS, the same rules apply as when a VNS
is created. That is — if the VNS's WLAN Service has a mode of:
•
"std" then the referenced role must have a topology of mode "b@ap," "b@ac," or "routed"
•
"3pap" then the referenced role must have a physical topology mode
Examples
The following example specifies that the role named "non-auth-users" should be used as the default
role for non-authenticated users for the VNS named VNS1:
WLC.siemens.com
WLC.siemens.com
name
Use the command in the vnsmode:<named-VNS> context to change the name of the current
name
VNS.
After you run the
name
name VNS-name
SCALANCE WLC711 CLI Reference Guide
:vnsmode:VNS1# auth auth-users
:vnsmode:VNS1# auth non-auth
:vnsmode:VNS1# apply
command to change the default role for non-authenticated clients. This command is
command, run the
Specifies the name of the role to use as the default role for non-
authenticated clients.
:vnsmode:VNS1# non-auth non-auth-users
:vnsmode:VNS1# apply
command, run the
apply
command to implement the changes.
apply
command to implement the changes.
VNS Commands (vnsmode)
non-auth
265