Siemens scalance WLC711 Reference Manual page 127

mcast-adaptable
Use the mcast
-adaptable
command is accessible from the ap:defaults:std, 11n, dualband, ap37xx, ap38xx, ap3801 and
adaptable
all radio1 and radio2 contexts of the CLI.
mcast-adaptable enable | disable
Parameters
enable
disable
Example
The following example enables adaptable multicast rate on radio1:
WLC.siemens.com
mcast2ucast
Use the mcast
2ucast
command is accessible from the ap:defaults:std, 11n, dualband, and ap38xx and all radio1 and radio2
contexts of the CLI.
mcast2ucast (disabled | auto)
Parameters
auto
disabled
Example
The following example makes multicast to unicast delivery automatic on radio1:
WLC.siemens.com
minbrate
Use this command to configure the minimum basic data rate for radio 2. The
accessible from all radio contexts of the CLI.
minbrate min-rate
Parameters
Valid values for min-rate depend on the radio mode:
SCALANCE WLC711 CLI Reference Guide
command to enable or disable an adaptable rate for multicasts. The
Enables the adaptable multicast rate on this radio.
Disables the adaptable multicast rate on this radio
:ap:defaults:ap37xx:radio1# mcast-adaptable enable
command to configure multicast to unicast delivery. The
Multicast to unicast delivery is automatic on this radio.
Multicast to unicast delivery is disabled on this radio.
:ap:defaults:ap37xx:radio1# mcast2ucast auto
ap Commands
mcast-adaptable
mcast-
mcast2ucast
command is
minbrate
127