Siemens scalance WLC711 Reference Manual page 119

admin-mode
Use this command to configure the administration status for the radio. The
accessible from all radio1 and radio2 contexts of the CLI.
admin-mode off | on
Parameters
off
on
Example
WLC.siemens.com
antsel
Use the command to configure the antenna, or antenna combination, you want to use for Radio
antsel
2. The command is accessible from the ap:defaults:11n, ap37xx, and ap38xx as well as
antsel
ap:<serial> CLI contexts for all 36xx, and 37xx, and 38xx APs, except for ap3705, ap3801, and ap3805.
After you run the
antsel
antsel (left | left-middle | left-middle-right)
Parameters
left
left-middle
left-middle-right
Usage
The antenna options available depend on the type of AP and the radio.
Example
The following example depicts Radio 2 of the Wireless 802.11n AP configured to use the left-middle-
right antenna combination:
WLC.siemens.com
atpc
Use the command to enable Auto Tx Power Ctrl (ATPC). Use the no form of the command to
atpc
disable the ATPC feature. The
CLI.
After you run the
atpc
SCALANCE WLC711 CLI Reference Guide
Clear the administrative status.
Set the administrative status.
:ap:defaults:11n:radio2# admin-mode on
command, run the
apply
Specifies the use of the left antenna on the AP.
Specifies the use of the left-middle antenna combination on the AP.
Specifies the use of the left-middle-right antenna combination on the AP.
:ap:defaults:11n:radio2# antsel left-middle-right
command is accessible from all radio1 and radio2 contexts of the
atpc
command, run the
apply
admin-mode
command to implement the change.
command to implement the change.
ap Commands
admin-mode
command is
119