Parameters
enable
disable
Example
The following example enables management traffic:
WLC.siemens.com
mtu
Use the
command to set the interface MTU (Maximum Transmission Unit), which specifies the
mtu
maximum allowable size, in bytes, of a data packet on the Ethernet port. The
available from the topology:<named-topology>:l3 context of the CLI for Admin, b@ac, physical, and
routed topologies.
mtu 576-1500
Parameters
576-1500
Example
The following example sets the size of the MTU to 1500 bytes:
WLC.siemens.com
netmask
Use the
command to optionally configure a netmask for a B@AC or B@AP topology. The
netmask
command is available from the topology:<named-topology> context of the CLI for b@ap or
netmask
b@ac topologies with disabled l3presence. If configured, the netmask will be used in the RADIUS
Accounting Framed-IP-Netmask attribute (assuming RADIUS accounting is using this topology).
netmask (netmask | CIDR | none)
Parameters
netmask
CIDR
none
SCALANCE WLC711 CLI Reference Guide
Enables management traffic.
Disable management traffic.
:topology:r1:l3:# mgmt enable
Specifies the size, in bytes, of the MTU.
:topology:r1:l3:# mtu 1500
Specifies the netmask in dotted-decimal notation.
Specifies the number of bits in the netmask that make up the network ID.
Specifies that no netmask is configured.
topology Commands
mtu
command is
mtu
367