Siemens scalance WLC711 Reference Manual page 85

The following example adds an OUI from a MAC address to the MAC address list:
WLC.siemens.com
The following example adds an IAB from a MAC address to the MAC address list:
WLC.siemens.com
mac-list-mode
Use this command to set the mode of the MAC address list. If the MAC address list mode is black, the
MAC addresses on the list identify clients that are not allowed to associate with the AP (a "blacklist"). If
the MAC list mode is white, only the clients identified by the MAC addresses on the list are allowed to
associate with the AP (a "whitelist").
mac-list-mode black | white
Parameters
black
white
Usage
If you change the mode from blacklist to whitelist, all existing MAC addresses on the list will be erased.
Use the command to list the current mode and entries in the MAC address list.
show
Examples
This example shows the system prompt printed when changing from black mode to white mode:
WLC.siemens.com
Change address list from whitelist to blacklist or vice versa will erase all
existing address. Are you sure to do it?
(yes/no):no
mac-list-sync-mode
Use this command to synchronize the blacklist and whitelist between two controllers configured in
availability.
mac-list-sync-mode enable | disable
Parameters
enable
disable
SCALANCE WLC711 CLI Reference Guide
.com:ap:blacklist# mac 22:22:22 24
:ap:blacklist# mac FF:FF:FF:FF:F 36
Sets the MAC address list as a blacklist, denying clients on the list access to the AP.
This is the default.
Sets the MAC address list as a whitelist, allowing only clients on the list access to the
AP.
:ap:blacklist# mac-list-mode white
Enables mac-list-sync-mode, which synchronizes MAC addresses between
controllers configured as blacklisted or whitelisted.
Disables mac-list-sync-mode, so that blacklisted or whitelisted MAC addresses are
not synchronized between controllers.
ap Commands
mac-list-mode
85