Siemens scalance WLC711 Reference Manual page 124

Usage
If force-disassociate is enabled, associated clients are sent disassociation frames if the average RSS is
less than RSS-threshold minus 5dBm.
Example
The following example enables force disassociate on radio 1 of AP 1111111111113705:
WLC.siemens.com
frag
Use the command to set the fragmentation threshold, which is the maximum size of a packet or
frag
data unit that can be delivered. Any data above this threshold is fragmented into packets that are less
than or equal to this limit. The
CLI.
frag value
Parameters
value
Example
The following example sets the fragmentation threshold to 1500:
WLC.siemens.com
hwretries
Use the
hwretries
effort transmission queue, video transmission queue, voice transmission queue, and turbo voice
transmission queue. The
ap:defaults:std, and ap:<serial> radio contexts of the CLI.
You can set each parameter — background transmission queue, best effort transmission queue, video
transmission queue, voice transmission queue and turbo voice transmission queue — to any value from
0 to 10 (0 means adaptive). Enter the letter "a" when specifying 10. For example if you were going to
enter 2, 4, 6, 8, 10 for the five values, you would enter 2468a, where a specifies 10 for the turbo voice
transmission queue value.
hwretries BK BE VI VO TVO
Parameters
BK
BE
SCALANCE WLC711 CLI Reference Guide
:ap:1111111111113705:radio1# force-disassociate enable
command is accessible from all radio1 and radio2 contexts of the
frag
Specifies the maximum size, measured in bytes, of any packet fragment for
delivery. The value range is 256 to 2346.
:ap:defaults:11n:radio2# frag 1500
command to set the number of retries for background transmission queue, best
command is accessible from the :defaults:dualband,
hwretries
Specifies the number of retries for the Background transmission queue.
Specifies the number of retries for the Best Effort transmission queue.
ap Commands
frag
124