Siemens scalance WLC711 Reference Manual page 403
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
radio1-load
Use the
radio1-load
Radio1. The
radio1-load
radio1-load value
Parameters
value
Example
The following example sets the maximum clients value for the Radio1 load balance group:
WLC.siemens.com
radio2-load
Use the
radio2-load
Radio2. The
radio2-load
radio2-load value
Parameters
value
Example
The following example sets the maximum clients value for the Radio2 load balance group:
WLC.siemens.com
radio1-loadcontrol
Use the
radio1-loadcontrol
only. The
radio1-loadcontrol
Radio Load Control activates only when the number of clients on the radio reaches the configured limit,
and does not disconnect any clients already connected. This is the default and preferred mode of load
control. Load control can be enabled on one radio and disabled on the other. Members of a WLAN load
control group are assigned to both radios and cannot be load controlled individually.
radio1-loadcontrol (enable | disable)
Parameters
(enable | disable)
SCALANCE WLC711 CLI Reference Guide
command to configure the maximum clients for the load balance group on
command is accessible from the site:<named-site> context.
Specifies the maximum clients for the load balance group. Valid values are 5-60.
:site:site1# radio1-load 55
command to configure the maximum clients for the load balance group on
command is accessible from the site:<named-site> context.
Specifies the maximum clients for the load balance group. Valid values are 5-60.
:site:site1# radio2-load 55
command to enable or disable load control (soft load limits) on Radio1
command is accessible from the site:<named-site> context.
Enables or disables the load control function on Radio1.
site Commands
radio1-load
403
Advertisement
Table of Contents
