13
snmp Commands
contact
context
enable
engine-id
location
port
publish-ap
rcommunity
rwcommunity
severity
show
trap-manager-v1v2
trap-manager-v3
user
The Wireless Appliance supports the Simple Network Management Protocol (SNMP) for retrieving
statistics and configuration information.
This section describes commands which manage SNMP settings for the Wireless Appliance. These
commands are located in the snmp context of the CLI.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
The following commands are available in the snmp context:
•
contact
on page 213
•
context
on page 213
•
enable
on page 213
•
engine-id
on page 214
•
location
on page 214
•
severity
on page 216
•
trap-manager-v1v2
•
trap-manager-v3
•
user
on page 218
•
show
on page 217
•
rwcommunity
•
port
on page 215
•
publish-ap
on page 215
•
show
on page 217
SCALANCE WLC711 CLI Reference Guide
on page 217
on page 218
on page 216
212