Siemens scalance WLC711 Reference Manual page 404

Example
The following example enables load control on Radio1:
WLC.siemens.com
radio2-loadcontrol
Use the
radio2-loadcontrol
only. The radio2-load
Radio Load Control activates only when the number of clients on the radio reaches the configured limit,
and does not disconnect any clients already connected. This is the default and preferred mode of load
control. Load control can be enabled on one radio and disabled on the other. Members of a WLAN load
control group are assigned to both radios and cannot be load controlled individually.
radio2-loadcontrol (enable | disable)
Parameters
(enable | disable)
Example
The following example disables load control on Radio2:
WLC.siemens.com
radio1-strictlimit
Use the
radio1-strictlimit
Radio1. When enabled, any clients in excess of the configured limits on the radio are immediately
disconnected. The
radio1-strictlimit (enable | disable)
Parameters
(enable | disable)
Usage
Radio Load Control must be enabled for this radio before this command can take effect.
Example
The following example enables strict load limiting on Radio1:
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:site:site1# radio1-loadcontrol enable
command to enable or disable load control (soft load limits) on Radio2
command is accessible from the site:<named-site> context.
control
Enables or disables the load control function on Radio2.
:site:site1# radio2-loadcontrol disable
command to enable or disable strict enforcement of hard load limits on
command is accessible from the site:<named-site> context.
radio1-strictlimit
Enables or disables the strict enforcement of load limits on Radio1.
:site:site1# radio1-strictlimit enable
site Commands
radio2-loadcontrol
404