Mitsubishi GOT1000 Series Connection Manual page 633

16.4.1 Connecting CPU port/D-sub 9-pin conversion cable
1 Setting of PLC CPU
Make the PLC CPU settings, displaying [Configuration]
development tool or the ladder-programming tool.
Item
*1
Communication mode
CPU PC link function settings
*1 The communication mode that can be selected differs according to the CPU.
Set the communication mode of the CPU (transmission speed and data format).
Set the transmission speed and data format according to settings of the transmission speed,
data length, parity and stop bit on the GOT side.
For details on these GOT side settings, refer to the following.
Section 16.3.3 Setting communication interface (Communication settings)
Item
Transmission
speed
Communication
9600bps
mode 0
Communication
9600bps
mode 1
Communication
19200bps
mode 2
Communication
19200bps
mode 3
Communication
38400bps
mode 4
Communication
38400bps
mode 5
Communication
57600bps
mode 6
Communication
57600bps
mode 7
Communication
115200bps
mode 8
Communication
115200bps
mode 9
Set the following when using the CPU programming port as the PC link function.
Make the checksum setting according to the sum check setting on the GOT side.
For the sum check setting on the GOT side, refer to the following.
Section 16.3.3 Setting communication interface (Communication settings)
Item
Use of PC link function
Checksum
End character
Protect function
16.4.1 Connecting CPU port/D-sub 9-pin conversion cable
[Communication setting] with the program
Setting
Transmission speed and data format
Data length Parity
8 bits Even
8 bits None
8 bits Even
8 bits None
8 bits Even
8 bits None
8 bits Even
8 bits None
8 bits Even
8 bits None
Setting
Mark. (Use enabled)
Mark. (ON) Do not mark. (OFF)
Do not mark. (OFF)
Do not mark. (OFF)
16.4 PLC Side Setting
9
10
11
Stop bit
1 bit
1 bit
12
1 bit
1 bit
1 bit
13
1 bit
1 bit
1 bit
14
1 bit
1 bit
15
16
16 - 29