When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT
User's Manual
16.3.6 Verifying GOT recognizes connected equipment
1
After powering up the GOT, touch [Main
Menu]
[Communication setting] from
the Utility.
2
The [Communication setting] appears.
3
Verify that the following communication
driver name is displayed in the box for
the communication interface to be used.
• Communication driver: YOKOGAWA
4
When the communication driver name is
not displayed normally, carry out the
following procedure again.
Section 16.3 Preparatory
Procedure for Monitoring
16.3 Preparatory Procedure for Monitoring
9
10
11
12
FA500/FA-M3
13
14
15
16
16 - 25