Mitsubishi GOT1000 Series Connection Manual page 1006

24.4.4 Station NO. settings
Set each station number while making sure that one station number is used only once.
The station number can be set without regard to the cable connection order.
No problem is expected even if station numbers are not consecutive.
GOT
(1) Direct specification
When setting the device, specify the station number of the servo amplifer of which data is to be
changed.
Specification range
0 to 31
(2) Indirect specification
When setting the device, indirectly specify the station number of the inverter of which data is to be
changed using the 16-bit GOT internal data register (GD10 to GD25).
When specifying the station No. from 100 to 115 on GT Designer2,the value of GD10 to GD25
compatible to the station No.specification will be the station No.of the servo amplifer.
Specification
statrion NO.
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
(3) All station specification
Target station differs depending on write-in operation or read-out operation.
• For write-in operation, all station will be a target.
• For read-out operation, only one station will be a target.
24 - 32
24.4 Setting on Servo Amplifier Side
24.4.4 Station NO. settings
Station NO.3 Station NO.0
Examples of station number setting
Compatible
device
GD10
GD11
GD12
GD13
GD14
GD15
GD16
0 to 31
GD17
For the setting other than the above, a communication
GD18
timeout error will occur.
GD19
GD20
GD21
GD22
GD23
GD24
GD25
Station NO.1 Station NO.21 Station NO. 6
Setting range