Mitsubishi GOT1000 Series Connection Manual page 807

2 Communication detail settings
Item
Transmission Speed
Data Bit
Stop Bit
Parity
Host Address
Format
Interrupt Data Byte
(1) Communication interface setting by Utility
The communication interface setting can be changed on the Utility's
"Communication setting" after downloading "Communication setting" of project
data.
For details on the Utility, refer to the following manual.
(2) Precedence in communication settings
When settings are made by GT Designer or the Utility, the latest setting is
effective.
(3)
Description
Set this item when change the transmission speed used for
communication with the connected equipment.
<Default: 19200bps>
Set this item when change the data length used for communication
with the connected equipment.
<Default: 7bits>
Specify the stop bit length for communications.
<Default: 1bit>
Specify whether or not to perform a parity check, and how it is
performed during communication.
<Default: Even>
Specify the host address (station No. of the GOT to which the
microcomputer is connected) in the connected network.
<Default: 0>
Select the communication format.
<Default: 1>
Specify the number of bytes of interrupt data.
<Default: 1byte>
GT User's Manual
19.6 Preparatory Procedures for Monitoring
19.6.3 Setting communication interface (Communication settings)
Range
4800bps, 9600bps,
19200bps, 38400bps,
57600bps, 115200bps
7bits or 8bits
1bit or 2 bits
None
Even
Odd
0 to 31
1 to 15
1byte, 2byte, 4byte
19 - 77
17
18
19
20
21
22
23
24