Precautions - Mitsubishi GOT1000 Series Connection Manual

27.3.11 Precautions

1 Using cyclic transmission
(1) I/O signal for master station
Do not turn on the reserved output signals in the output signals (remote output: RY) to the GOT
from the master station.
When the reserved output signal is turned on, the CNC system may be malfunctioned.
For the assignment of I/O signals in the GOT, refer to the following manual.
GT15 CC-Link communication unit User's Manual
(2) Access range that can be monitored
The CC-Link communication unit mounted to the GOT is compatible with CC-Link Ver. 1.
For this reason, the monitoring range of remote I/O (RX and RY) and that of the remote registers
(RWr and RWw) vary according to the mode in the master station of the CC-Link system.
Mode of master station
Remote net mode
Remote net ver.1 mode
Remote net ver.2 mode
Remote net additional mode
2 For transient transmission
(1) Access range that can be monitored
The GOT can access to the CNC mounting the master and local station of the CC-Link System.
It cannot access another network via the CC-Link module.
3 Version of CNC
For MELDAS C6/C64, use NC system software version D0 or later.
Applicable of monitoring
Data for each station compatible with
CC-Link ver.1
: Applicable
27.3 CC-Link Connection (Intelligent Device Station)
Data for each station compatible with
CC-Link ver.2
: N/A(All "0") : N/A of system configuration
27.3.11 Precautions
25
26
27
28
29
30
31
27 - 61