Mitsubishi GOT1000 Series Connection Manual page 385

2 Setting PLC system settings (common to CJ1 and CS1)
Make the PLC system settings.
Channel
160
161
163
*1 Only transmission speeds available on the GOT side are shown.
*2 Set the same port transmission speed as that of the GOT side.
For the transmission speed setting on the GOT side, refer to the following.
Section 9.3.3 Setting communication interface (Communication settings)
*3 Set the host link station No. according to the Host Address on the GOT side.
For the Host Address setting on the GOT side, refer to the following.
Section 9.3.3 Setting communication interface (Communication settings)
Remark
Precautions for changing the PLC system settings
Before changing the PLC system settings, make sure that the switch settings have
been changed as follows:
CJ1, CS1: Front panel DIP switch SW5 to "OFF"
Bit Item
15 Arbitrary settings ON/OFF
8 to 11 Serial communication mode
3 Data length
2 Stop bit
0 to 1 Parity
0 to 7
Port transmission speed
0 to 7
Host link station No.
1 : Arbitrary settings (fixed)
H
0 : Upper link (fixed)
H
0 : 7 bits (fixed)
H
0 : 2 bits (fixed)
H
0 : Even (fixed)
H
00 : 9600bps 08
H
05 : 4800bps 09
H
*1*2
06 : 9600bps 0A
H
07 : 19200bps
H
*3
0 to 1F : No.00 to 31
H H
9.4 PLC Side Setting
9.4.2 Connecting CJ1 or CS1
Setting
: 38400bps
H
: 57600bps
H
: 115200bps
H
9 - 41
9
10
11
12
13
14
15
16