Mitsubishi GOT1000 Series Connection Manual page 754

(4) Formats 11 to 13 (Digital Electronics Corporation's memory link method)
This is the same format as the protocol of the Digital Electronics Corporation's memory link
method.
Type
Digital Electronics Corporation's memory link
Format 11
method (compatible mode)
Digital Electronics Corporation's memory link
Format 12
method (extended mode, ASCII code 1:1)
Digital Electronics Corporation's memory link
Format 13
method (extended mode, ASCII code 1:n)
(5) Formats 14, 15 (GOT-F900 series microcomputer connection)
This is the same message format as when a microcomputer connection is established with the
GOT-F900 Series.
Type
GOT-F900 series microcomputer connection
Format 14
(format 1)
GOT-F900 series microcomputer connection
Format 15
(format 2)
2 How to set data format
Set the data format at "Communication Detail Settings" in GT Designer2.
For details of the data format setting method, refer to the following.
19 - 24
19.5 Message Formats
19.5.1 Data format type and application
Name
Name
Section 19.6.3 Setting communication interface (Communication settings)
Description
This is the basic format of the Digital Electronics Corporation's
memory link method.
This is the appended format of the Digital Electronics Corporation's
memory link method (compatible mode) with sum check, CR and LF.
This is the appended format of the Digital Electronics Corporation's
memory link method (extended mode, ASCII code 1:1) with a station
No.
Description
Use this format when establishing a 1:1 or m:n connection between
the GOT and the host.
The end code is CR.
Use this format when establishing a 1:1 or m:n connection between
the GOT and the host.
The end code is ETX or sum check.
Reference
Section
19.5.6
Reference
Section
19.5.7