Mitsubishi GOT1000 Series Connection Manual page 1024

2 Bar code reader setting
The bar code reader shall be configured as shown below.
Baud rate
Data length
Stop bit
Parity
Header
Terminator
3 "Communication settings" in GT Designer2
(1) Communication settings
(2) Barcode
Keep consistency with the bar code reader setting.
Transmission Speed
Data Bit
Stop Bit
Parity
25 - 16
25.4 System Configuration Examples
Item
Bar code reader setting
For the bar code reader setting, refer to the following manual.
The User's Manual of the bar code reader you are using
Item
"Communication settings" in GT Designer2
For the "Communication settings" in GT Designer2, refer to the following.
Section 25.2.3 Setting communication interface (Communication settings)
Setting
9600bps
8bit
1bit
Even
None
CR
Setting (Use default value.)
9600bps
8bit
1bit
Even