Mitsubishi GOT1000 Series Connection Manual page 916

22.3 Preparatory Procedures for Monitoring
The following shows the procedures to be taken before monitoring and corresponding reference sections.
Install the OS onto the GOT.
Make sure that the OS is installed on the GOT.
Set the communication interface. (Communication
settings)
Download the project data.
Attach the communication unit and connect the cable.
Make sure that the GOT recognizes the connected
equipment.
Make sure that monitoring is performed normally.
22 - 16
22.3 Preparatory Procedures for Monitoring
Confirming the temperature controller side setting
This section explains the temperature controller side setting.
When confirming the temperature controller side setting, refer to the following.
Section 22.4 Temperature Controller Side Setting
Section 22.3.1
Installing OS onto GOT
Section 22.3.2
Checking OS installation on GOT
Section 22.3.3
Setting communication interface
(Communication settings)
Section 22.3.4
Downloading project data
Section 22.3.5
Attaching communication unit and
connecting cable
Section 22.3.6
Verifying GOT recognizes connected
equipment
Section 22.3.7
Checking for normal monitoring