Cnc Side Settings - Mitsubishi GOT1000 Series Connection Manual

Graphic operation terminal

Hide thumbs Also See for GOT1000 Series:

Table of Contents

27.3.10 CNC Side Settings

Parameter Setting

Set parameters related to CC-Link with MELSEC's peripheral devices in the same way as parameter

setting of MELSEC CPU, and write them on CNC by PC. However, in the case of using the local

stations, it is not necessary to set the network parameters.

(1) Master station parameter

If you wish to place the master station in CNC and set the common parameters, set the network

parameters by peripheral device and write them on CNC. An example of parameter setting by

GPPW is as follows.

Set the first I/O No. as follows according to the expansion slot to which the unit is inserted.

(a) Start I/O No.

(b) Example of GX Developer setting

For details of the parameter setting, refer to the following.

27.3 CC-Link Connection (Intelligent Device Station)

27.3.10 CNC Side Settings

Start I/O No.

MELDAS C6/C64 NETWORK MANUAL BNP-B2373

Show Quick Links

Table of Contents