Mitsubishi GOT1000 Series Connection Manual page 466

11 - 32
11.3 Preparatory Procedures for Monitoring
11.3.6 Verifying GOT recognizes connected equipment
When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT User's Manual
1 After powering up the GOT, touch [Main
Menu] [Communication setting] from
the Utility.
2 The [Communication setting] appears.
3 Verify that the following communication
driver name is displayed in the box for
the communication interface to be used.
• Communication driver: SHARP JW
4 When the communication driver name is
not displayed normally, carry out the
following procedure again.
• Section 11.3 Preparatory
Procedures for Monitoring