Cnc Side Settings - Mitsubishi GOT1000 Series Connection Manual

Graphic operation terminal

Hide thumbs Also See for GOT1000 Series:

Table of Contents

27.2.10 CNC Side Settings

Parameter Setting

Set parameters related to MELSECNET/10 with MELSEC's peripheral devices in the same way as

parameter setting of MELSEC CPU, and write them on CNC by PC. However, in the case of using the

default parameters or not requiring separate settings due to normal stations, it is not necessary to set

(1) Control Station Parameter

If you wish to place the control station in CNC and set the common parameters, set the network

parameters by peripheral device and write them on CNC. An example of parameter setting by

GPPW is as follows.

Set the first I/O No. as follows according to the expansion slot to which the unit is inserted.

(a) Start I/O No.

(b) Example of GX Developer setting

For details of the parameter setting, refer to the following.

(2) Normal Station Parameter

As for normal stations, it is not necessary to set parameters unless separate settings are required.

The refresh parameters are set and written as required. In this case, the parameter setting of the

first I/O No. is the same as in the case of the control station.

27.2 MELSECNET/10 Connection (PLC To PLC Network)

27.2.10 CNC Side Settings

Start I/O No.

MELDAS C6/C64 NETWORK MANUAL BNP-B2373

Show Quick Links

Table of Contents