Mitsubishi GOT1000 Series Connection Manual page 891

When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT User's Manual
21.3.6 Verifying GOT recognizes connected equipment
1 After powering up the GOT, touch [Main
Menu] [Communication setting] from
the Utility.
2 The [Communication setting] appears.
3 Verify that the following communication
driver name is displayed in the box for the
communication interface to be used.
• Communication driver: YAMATAKE
4 When the communication driver name is
not displayed normally, carry out the
following procedure again.
Section 21.3 Preparatory
Procedures for Monitoring
21.3 Preparatory Procedures for Monitoring
17
18
19
20
SDC/DMC
21
22
23
24
21 - 35