Mitsubishi GOT1000 Series Connection Manual page 1119

(2) When using the "PING Test" of GT Designer2
Select [Communication]
"PING Test".
(1) When abnormal communication
At abnormal communication, check the followings and execute the Ping command again.
• Mounting condition of Ethernet communication unit
• Cable connecting condition
• Confirmation of "Communication settings"
• IP address of GOT svpecified by Ping command
3 Confirming the CNC side setting
When connecting the GOT, setting is required for the CNC side.
Confirm if the CNC side setting is correct.
Section 27.4.10 CNC Side Settings
[Communication configuration]
1
2
27.4.9 Checking for normal monitoring
"Ethernet" and
Test
Specify the "GOT IP address" of the
"PING Test" and click on the
button.
The "Test Result" is displayed after the
"PING Test" is finished.
27.4 Ethernet Connection
25
to display
26
PING Test
27
28
29
30
31
27 - 77