Mitsubishi GOT1000 Series Connection Manual page 336

3 Sequence program
The sequence program for initial processing and communication line opening processing are required.
(1) Programming condition
This program performs the initial processing of the Ethernet module and the opening processing of
connection No. 1 when the stopping PLC CPU starts running.
(a) I/O signal of Ethernet module
(b) Device used by user
D112 to D113
8 - 32
8.3 PLC Side Setting
8.3.3 Connecting to Ethernet module (A Series)
For A Ethernet Interface Module User's Manual
Device
M102 COM.ERR turned off command
D100 IP address of Ethernet module
D110 Application setting
D111 Port No. of Ethernet module
IP address of GOT
D114 Port No. of GOT
D200 Initial fault code
Application