Mitsubishi GOT1000 Series Connection Manual page 435

CONNECTION TO
SHARP PLC
11.1 System Configuration . . . . . . . . . page 11-2
This section describes the equipment and cables needed
when connecting a GOT to a SHARP PLC.
Select a system suitable for your application.
11.2 Connection Cable . . . . . . . . . . . page 11-15
This section describes the specifications of the cables
needed when connecting a GOT to a SHARP PLC.
Check the specifications of the connection cables.
11.3 Preparatory Procedures for Monitoring . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . page 11-21
This section provides the procedures to be followed before
performing monitoring in connection to a SHARP PLC.
The procedures are written on the step-by-step basis so
that even a novice GOT user can follow them to start
communications.
11.4 PLC Side Setting . . . . . . . . . . . . page 11-35
The PLC side settings for GOT connection are explained.
When checking the PLC side settings, refer to this section.
11.5 List of Functions Added by Version Upgrade
. . . . . . . . . . . . . . . . . . . . . . . . . page 11-42
This section describes the functions added by version
upgrade of GT Designer2 or OS.
11
11 - 1
9
10
11
12
13
14
15
16