Mitsubishi GOT1000 Series Connection Manual page 176

4 - 36
4.3 Preparatory Procedures for Monitoring
4.3.6 Verifying GOT recognizes connected equipment
When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT User's Manual
1 After powering up the GOT, touch [Main
Menu] [Communication setting] from
the Utility.
2 The [Communication setting] appears.
3 Verify that the following communication
driver name is displayed in the box for the
communication interface to be used.
• Communication driver
(either of the following)
A/QnA/QCPU, QJ71C24
AJ71QC24
AJ71C24/UC24
4 When the communication driver name is
not displayed normally, carry out the
following procedure again.
Section 4.3 Preparatory
Procedures for Monitoring