Mitsubishi GOT1000 Series Connection Manual page 326

(2) Operational settings
Communication date code
IP address
Initial timing
Send frame setting
Enable Write at RUN time
TCP Existence confirmation setting
*1 Because port No. 5001 is fixed, these items operate at the following setting without relations to the setting given
here.
• Communication date code
• Initial timing
• Enable Write at RUN time
(3) Communication confirmation
The INIT. LED on the Ethernet module turn on when the module is ready to communicate.
For confirming the communication state, refer to the following.
Confirming the communication state of Ethernet module
QJ71E71-100
RUN
INIT.
OPEN
SD
*2 The LEDs layout of QJ71E71-100.
8 - 22
8.3 PLC Side Setting
8.3.1 Connecting to Ethernet module (Q Series)
Item
*1
*1
*1
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU ether
turning OFF and then ON or resetting.
*2
ERR.
COM.ERR.
100M
RD
Setting
(Use default value.)
192.168.0.19
(Use default value.)
: Necessary
: "Binary code"
: "Always wait for OPEN" (Communication is applicable while stopping the
PLC CPU.)
: "Enable Write at RUN time" (Writing Data is applicable while running the
PLC CPU.)
Setting necessity at GOT
connection
: As necessary : Not necessary